Browsing Ukrainian translation

68.

PURPOSE:
This test will check that you can record and hear audio using a bluetooth audio device
STEPS:
1. Enable the bluetooth headset
2. Click on the bluetooth icon in the menu bar
3. Select 'Setup new device'
4. Look for the device in the list and select it
5. In the device write the PIN code automatically chosen by the wizard
6. The device should pair with the computer
7. Click the sound icon
8. Click "Sound Settings"
9. Select device and ensure Quality is set to "HSP/HFP"
10. Click "Test" to record for five seconds and reproduce in the bluetooth device
VERIFICATION:
Did you hear the sound you recorded in the bluetooth

100.

PURPOSE:
This test checks that a systems drive protection mechanism works properly.
STEPS:
1. Click on Test
2. Move the system under test around, ensuring it is raised and lowered at some point.
VERIFICATION:
The verification of this test is automated. Do not change the
automatically selected result.

102.

PURPOSE:
This test will check your wired connection
STEPS:
1. Click on the Network icon in the top panel
2. Select a network below the "Wired network" section
3. Click "Test" to verify that it's possible to establish a HTTP connection
VERIFICATION:
Did a notification show and was the connection correctly established?

103.

Automated test to walk multiple network cards and test each one in sequence.

104.

This is an automated test to gather some info on the current state of your network devices. If no devices are found, the test will exit with an error.

105.

This test executes a maximum throughput test against all the ethernet devices found on the system.

106.

Automated test that tests performance of each wired network device under stress.

110.

PURPOSE:
This will verify that an ExpressCard slot can detect inserted devices.
STEPS:
Skip this test if you do not have an ExpressCard slot.
1. Plug an ExpressCard device into the ExpressCard slot
VERIFICATION:
Was the device correctly detected?

111.

PURPOSE:
This test will verify that a fingerprint reader will work properly for logging into your system. This test case assumes that there's a testing account from which test cases are run and a personal account that the tester uses to verify the fingerprint reader
STEPS:
1. Click on the User indicator on the left side of the panel (your user name).
2. Select "Switch User Account"
3. On the LightDM screen select your username.
4. Use the fingerprint reader to login.
5. Click on the user switcher applet.
6. Select the testing account to continue running tests.
VERIFICATION:
Did the authentication procedure work correctly?

116.

Automated tests for firmware using Firmware Test Suite.