|
861.
|
|
|
If specified, directs the device to only associate with the given access point. This capability is highly driver dependent and not supported by all devices. Note: this property does not control the BSSID used when creating an Ad-Hoc network and is unlikely to in the future.
|
|
|
|
Якщо вказано, спрямовує пристрій на прив’язування до заданої точки доступу. Використання цієї можливості залежить від драйвера і підтримується не для усіх пристроїв. Зауваження: ця властивість не керує BSSID, який використовується для створення ситуативної мережі, і малоймовірно, що керуватиме ним у майбутньому.
|
|
Translated by
yurchor
|
|
|
|
Located in
../clients/common/settings-docs.c.in:8
|
|
917.
|
|
|
Specifies authentication flags to use in "phase 1" outer authentication using NMSetting8021xAuthFlags options. The individual TLS versions can be explicitly disabled. If a certain TLS disable flag is not set, it is up to the supplicant to allow or forbid it. The TLS options map to tls_disable_tlsv1_x settings. See the wpa_supplicant documentation for more details.
|
|
|
|
Визначає прапорці розпізнавання, якими слід користуватися під час «фази 1» зовнішнього розпізнавання з використанням параметрів NMSetting8021xAuthFlags. Окремі версії TLS може бути вимкнено явним чином. Якщо певний прапорець вимикання TLS не встановлено, дозвіл або заборону версії виконає допоміжна програма. Параметри TLS пов’язано із параметрами tls_disable_tlsv1_x. Докладнішу інформацію можна знайти у документації до wpa_supplicant.
|
|
Translated by
yurchor
|
|
|
|
Located in
../clients/common/settings-docs.c.in:63
|
|
1002.
|
|
|
The autoconnect priority. If the connection is set to autoconnect, connections with higher priority will be preferred. Defaults to 0. The higher number means higher priority.
|
|
|
|
Пріоритетність автоматичного з’єднання. Якщо для з’єднання встановлено автоматичне з’єднування, перевага надаватиметься з’єднанням із вищою пріоритетністю Типовим значенням пріоритетності є 0. Більші значення означають вищу пріоритетність.
|
|
Translated by
yurchor
|
|
|
|
Located in
../clients/common/settings-docs.c.in:139
|
|
1022.
|
|
|
A universally unique identifier for the connection, for example generated with libuuid. It should be assigned when the connection is created, and never changed as long as the connection still applies to the same network. For example, it should not be changed when the "id" property or NMSettingIP4Config changes, but might need to be re-created when the Wi-Fi SSID, mobile broadband network provider, or "type" property changes. The UUID must be in the format "2815492f-7e56-435e-b2e9-246bd7cdc664" (ie, contains only hexadecimal characters and "-").
|
|
|
|
Універсальний унікальний ідентифікатор (UUID) з’єднання, наприклад ідентифікатор, створений за допомогою libuuid. Ідентифікатор має бути пов’язано зі з’єднанням під час його створення. Ідентифікатор має лишатися незмінним, аж доки з’єднання не змінює мережі. Наприклад, ідентифікатор не повинен змінюватися, якщо змінилися значення властивості «id» або параметра NMSettingIP4Config, але може виникнути потреба у його повторному створенні, якщо змінилося значення SSID Wi-Fi, оператор мобільної широкосмугової мережі або значення властивості «type». UUID має бути вказано у форматі «2815492f-7e56-435e-b2e9-246bd7cdc664» (тобто у форматі запису, який містить лише шістнадцяткові цифри і символи «-»).
|
|
Translated by
yurchor
|
|
|
|
Located in
../clients/common/settings-docs.c.in:157
|
|
1094.
|
|
|
Configure method for creating the address for use with RFC4862 IPv6 Stateless Address Autoconfiguration. The permitted values are: NM_SETTING_IP6_CONFIG_ADDR_GEN_MODE_EUI64 (0) or NM_SETTING_IP6_CONFIG_ADDR_GEN_MODE_STABLE_PRIVACY (1). If the property is set to EUI64, the addresses will be generated using the interface tokens derived from hardware address. This makes the host part of the address to stay constant, making it possible to track host's presence when it changes networks. The address changes when the interface hardware is replaced. The value of stable-privacy enables use of cryptographically secure hash of a secret host-specific key along with the connection's stable-id and the network address as specified by RFC7217. This makes it impossible to use the address track host's presence, and makes the address stable when the network interface hardware is replaced. On D-Bus, the absence of an addr-gen-mode setting equals enabling stable-privacy. For keyfile plugin, the absence of the setting on disk means EUI64 so that the property doesn't change on upgrade from older versions. Note that this setting is distinct from the Privacy Extensions as configured by "ip6-privacy" property and it does not affect the temporary addresses configured with this option.
|
|
|
|
Спосіб налаштовування для створення адреси для використання з автоналаштовуванням адрес IPv6 без врахування стану за RFC4862. Дозволені значення: NM_SETTING_IP6_CONFIG_ADDR_GEN_MODE_EUI64 (0) і NM_SETTING_IP6_CONFIG_ADDR_GEN_MODE_STABLE_PRIVACY (1). Якщо для властивості встановлено значення EUI64, адреси буде створено за допомогою ключів інтерфейсу, що походять із апаратної адреси. Це зробить частину адреси, пов’язану із вузлом, сталою і уможливить стеження за наявністю вузла при зміні мереж. Адресу буде змінено, якщо буде замінено апаратну частину інтерфейсу. Значення «stable-privacy» уможливлює використання криптографічно безпечного хешу закритого специфічного для вузла ключа разом із стабільним ідентифікатором з’єднання та мережевою адресою, як це описано у RFC7217. Це робить неможливим використання адресного стеження за наявністю вузла і робить адресу незмінною, якщо замінюється апаратна частина інтерфейсу. У D-Bus нестача параметра addr-gen-mode означає, що увімкнено «stable-privacy». Для додатка ключа у файлі нестача параметра на диску означає, що використано спосіб EUI64, отже властивість не змінюється при оновленні застарілих версій. Зауважте, що цей параметр відрізняється від розширень конфіденційності, які налаштовуються властивістю «ip6-privacy», і не впливає на тимчасові адреси, які налаштовано за допомогою відповідної властивості.
|
|
Translated by
yurchor
|
|
|
|
|
| msgid ""
| "Configure method for creating the address for use with RFC4862 IPv6 "
| "Stateless Address Autoconfiguration. The permitted values are: \"eui64\", "
| "or \"stable-privacy\". If the property is set to \"eui64\", the addresses "
| "will be generated using the interface tokens derived from hardware "
| "address. This makes the host part of the address to stay constant, making "
| "it possible to track host's presence when it changes networks. The "
| "address changes when the interface hardware is replaced. The value of "
| "\"stable-privacy\" enables use of cryptographically secure hash of a "
| "secret host-specific key along with the connection's stable-id and the "
| "network address as specified by RFC7217. This makes it impossible to use "
| "the address track host's presence, and makes the address stable when the "
| "network interface hardware is replaced. On D-Bus, the absence of an addr-"
| "gen-mode setting equals enabling \"stable-privacy\". For keyfile plugin, "
| "the absence of the setting on disk means \"eui64\" so that the property "
| "doesn't change on upgrade from older versions. Note that this setting is "
| "distinct from the Privacy Extensions as configured by \"ip6-privacy\" "
| "property and it does not affect the temporary addresses configured with "
| "this option."
|
|
Located in
../clients/common/settings-docs.c.in:231
|
|
1100.
|
|
|
The pre-shared CAK (Connectivity Association Key) for MACsec Key Agreement.
|
|
|
|
Попереднього поширений CAK (ключ прив’язки з’єднань) для узгодження ключів MACsec.
|
|
Translated by
yurchor
|
|
|
|
Located in
../clients/common/settings-docs.c.in:254
|
|
1102.
|
|
|
The pre-shared CKN (Connectivity-association Key Name) for MACsec Key Agreement.
|
|
|
|
Попереднього поширена CKN (назва ключа ключ прив’язки з’єднань) для узгодження ключів MACsec.
|
|
Translated by
yurchor
|
|
|
|
Located in
../clients/common/settings-docs.c.in:256
|
|
1155.
|
|
|
PAC script for the connection.
|
|
|
|
Скрипт PAC для з’єднання.
|
|
Translated by
yurchor
|
|
|
|
Located in
../clients/common/settings-docs.c.in:311
|
|
1228.
|
|
|
If specified, this connection will only apply to the WiMAX device whose MAC address matches. This property does not change the MAC address of the device (known as MAC spoofing). Deprecated: 1
|
|
|
|
Якщо вказано, це з’єднання застосовуватиметься лише до пристрою WiMAX із відповідною адресою MAC. Ця властивість не змінює MAC-адреси пристрою (таку зміну називають підміною MAC). Застаріле: 1
|
|
Translated by
yurchor
|
|
|
|
Located in
../clients/common/settings-docs.c.in:386
|
|
1229.
|
|
|
Network Service Provider (NSP) name of the WiMAX network this connection should use. Deprecated: 1
|
|
|
|
Назва надавача мережевих послуг (NSP) для мережі WiMAX, яку має використовувати це з’єднання. Застаріле: 1
|
|
Translated by
yurchor
|
|
|
|
Located in
../clients/common/settings-docs.c.in:388
|